Fig. 1 ->
Fig. 2 ->
Fig. 3 ->
Fig. 4 ->
| I made a holder to hold one of the small HDIs at 90°. The
HDI bends of the 3 modules at BNL had relaxed by ~25°.
Fig. 1 -> |
|
| Measurements were taken from
the model, with stops at 68.3mm
horizontal and 27.8mm vertical.
Fig. 2 -> |
|
| The HDI did not fit - the neck was too long.
Fig. 3 -> |
|
| After cutting 5mm off the vertical stop, the module fit, and
was placed back in the dry box at about 15:00 Wed Oct 27.
The next day, the HDI relaxation angle had decreased from 25° to
15°.
Fig. 4 -> |
|