Some Tools Needed
Ability to pull raw data “all the way up” to analysis workstations
- DCM in pass-thru mode
- You can pad bits, add header/trailer, but DO NOT mess with the FEM’s basic payload
Histogramming, peak fitting
- Running sums, means, rms?
Much of “tuneup” can
- write to disk,analyze, examine, tune parameters
- discard “last data” and re-start/repeat
Store and query in “database”
- “Best”place to store pedestals may be (only?) in DCM memory
Over-ride of LVL-1 decision (Forced Accept)
Way to move events by 1-few “ticks” in Scheduler
Write/Readback/Compare/Alarm-on-Non-Match of Serial via ARCnet