| We placed 2 wedges on a spare large disk and tried to run through the
steps of installing it.
| 
|
| The first problem we had was the disk holder that is supposed to allow us
to lower the disk into the cage. The disk holder's srew holes are too
large and not tapped out. There is a bar that is supposed to attach to
it, and has the same problem. Because of this we could not attach the
hoop that is supposed to hold the cables in place, or attach the disk to
the holder. This is just as well because the holder will not lower the
disk into place correctly. The legs push against the cage before the disk
is all the way lowered. All the holders (station 1-3 at at least) have
this problem.
| 
|
| We placed the disk in positions 1-3 and it fit correctly. The frame the
cage is in intereferes with some of the station 1 screw holes, it is
difficult the get the screw in but not impossible. It might help if Mike
cut a notch out of the holder right there.
| 
|
|
| 
|
| We had some cables for station 1 and 2, they looked fine, a little tight
but probably ok. We did not attach the HV cables, just an oversight but
we do have them. I see they are supposed to lay along the extension
cables, is there any plan to keep them in place?
| 
|
| xxx
| 
|