---------------------------- | Drill Engine Log | | Started | | Wed Oct 15 09:06:19 2008 | ---------------------------- Removing Output/NCDrill/1-8Plated.ncd Removing Output/NCDrill/8-16Plated.ncd Removing Output/NCDrill/ThruHoleNonPlated.ncd Removing Output/NCDrill/ThruHolePlated.ncd Warning, Duplicate hole using T12 (Drill 8) detected at XY -5.9112, 2.3156 Created drill file "Output/NCDrill/ThruHolePlated.ncd" for span from 1 to 16 Total holes, contours in this file 4912, 0 Tool Size (IN) Tolerance (IN) Plated Count ---- --------- ----------------- ------ ----- 12 0.0080 +/- 0.0030 YES 4372 19 0.0100 YES 2 13 0.0150 YES 89 01 0.0230 YES 72 14 0.0280 YES 133 03 0.0330 YES 9 11 0.0350 YES 4 09 0.0370 YES 49 07 0.0390 YES 10 02 0.0400 YES 96 08 0.0410 YES 10 04 0.0450 YES 12 22 0.0470 YES 8 05 0.0630 YES 4 06 0.0670 YES 16 10 0.0720 YES 24 25 0.1300 YES 2 Created drill file "Output/NCDrill/ThruHoleNonPlated.ncd" for span from 1 to 16 Total holes, contours in this file 36, 0 Tool Size (IN) Tolerance (IN) Plated Count ---- --------- ----------------- ------ ----- 20 0.0400 NO 12 21 0.0610 NO 14 24 0.0670 NO 4 23 0.1140 NO 6 Created drill file "Output/NCDrill/1-8Plated.ncd" for span from 1 to 8 Total holes, contours in this file 1007, 0 Tool Size (IN) Tolerance (IN) Plated Count ---- --------- ----------------- ------ ----- 15 0.0080 +/- 0.0030 YES 959 17 0.0470 YES 48 Created drill file "Output/NCDrill/8-16Plated.ncd" for span from 8 to 16 Total holes, contours in this file 103, 0 Tool Size (IN) Tolerance (IN) Plated Count ---- --------- ----------------- ------ ----- 16 0.0080 +/- 0.0030 YES 63 18 0.0470 YES 40 ---------------------------- | Drill Engine Log | | Finished | | Wed Oct 15 09:06:20 2008 | ----------------------------